Infinix Hot 10S Rear Back Panel Housing Replacement, Green - Verified Fit

About this product

This is a rear back body housing and battery door replacement built specifically for the Infinix Hot 10S, a 6.82-inch IPS LCD device measuring 171.8 x 78.3 x 8.9mm with a plastic back and plastic frame construction. It replaces the entire outer back shell — not just a snap-on cover — so it restores the phone's original structural panel when the factory back is cracked, scratched through, or missing. The panel is molded and finished in Green to match the Morandi Green colorway Infinix shipped alongside Heart of Ocean, 7 Degree Purple, and Black. Because the Hot 10S carries a 48MP + 2MP + AI triple-lens rear camera array, the housing's camera cutout is shaped and positioned to that exact lens cluster, not a generic round or square opening.

• Color-matched Morandi Green finish over the same plastic-back, plastic-frame construction as the original panel
• Camera cutout profiled to the 48MP main + 2MP depth + AI lens arrangement
• Cutout aligned to the Micro-USB charging port at the base of the 171.8mm-tall body
• Speaker grille and microphone openings positioned for the Hot 10S chassis
• Side cutouts for the volume rocker and power button
• Sized to sit flush on a device that weighs 207g, without adding noticeable bulk

How it fits your Infinix Hot 10S

Fit is built around the Hot 10S's exact 171.8 x 78.3 x 8.9mm frame and 207g weight, so the panel seats into the same mounting points as the factory plastic back rather than clipping over it like a case. The camera window is cut to the triple-lens layout of the 48MP + 2MP + AI camera, with a raised inner lip meant to keep the lens ring seated flush rather than floating loose inside an oversized hole. Along the bottom edge, the port cutout lines up with the Hot 10S's Micro-USB connector, and a slot near the top clears the 3.5mm headphone jack the device still carries. Because this model has no wireless charging coil and no NFC antenna to route around (both are absent on the Hot 10S), the housing's inner face is a simpler, uninterrupted plastic shell rather than one built with coil clearance cutouts — which is one reason back-door parts are not interchangeable across Infinix models that do support NFC or wireless charging.

What you should know

This housing is verified to fit the Infinix Hot 10S only, in the Green finish matching the Morandi Green retail color — it is not built for the Hot 10, Hot 10 Play, Hot 10i, Hot 11, or any other Infinix Hot-series model, even where dimensions look similar on paper. It is a structural and cosmetic replacement panel, not a protective case: it restores the phone's outer shell and covers the internal battery compartment, but it does not add drop cushioning, raised bezels, or shock absorption the way a silicone or TPU cover would. Fitting it requires opening the phone to remove the damaged original back and transfer or reseat internal hardware, so this is a job we recommend leaving to a phone technician rather than a DIY swap, particularly since disassembly can affect any remaining manufacturer warranty on the device. Note that this listing is the back housing itself, not a battery cell — the Hot 10S's 6000mAh battery sits underneath it and is not included.

Buying with confidence

Dastyab.pk backs this listing with a 7-day return window on unused, unopened items if the fit or finish isn't right, and we ship nationwide across Pakistan. Compatibility here is checked against the Infinix Hot 10S's actual published dimensions and camera layout rather than a generic "universal fit" claim, so what you see is what was matched to this specific device.